206M 201805
31
Fig 7-9
Input rim data, manually rotate wheel, when display shows “RUN ---”, move hand away
to let wheel rotate. When display shows “STOP”, wheel stops and display shows data. Slowly
rotate wheel, when inside position indication LEDs all light,
（
Fig 5-1
（
10
）
）
, at the 12 o’clock
position of rim inside aI position, stick weights equal to value shown on the left side display.
Then slowly rotate wheel, when outside position indication LEDs all light,
（
Fig 5-1
（
11
）
）
, at the
12 o’clock position of rim outside aE position, stick weights equal to value shown on the right
side display. Rotate wheel by hand again, when display shows “RUN ---”, move hand away
to let wheel rotate. When both side display show 0, balancing is completed
7.8 Counterweight split and Hidden-Stick Mode
This mode can split counterweights between two spokes into two section counterweight
and the two section counterweights may be sticked behind two adjacent spokes so that
counterweights are hidden . This mode is based on ALU-S mode.
Follow 7.7 operation, if outer side counterweight sticking position is not behind spokes,
and user needs to hide counterweight behind spokes, user can operate as follows:
Press [FUNC] key, SPLIT indicator light
（
Fig 5-1
（
16
）
）
is on, spoke numbers inputting
interface appears
（
Fig 7-10
）
. Press b+ or b- key to input spoke numbers, press [FUNC]
key;
Fig 7-10
Slowly rotate wheel, make one piece spoke vertical upwards, press [FUNC] key
Slowly rotate wheel, find two imbalance positions following the imbalance position
indication light, stick counterweights equal to two sections value at 12 o’clock position
behind spokes. Quickly rotate wheel to balance wheel. Counterweights split and hidden
operation is completed.
7.9 Recalculation
Before wheel balance testing, sometimes operator may forget input current data of rim.
Data can be inputted after wheel balance testing. Then it is not necessary to make balancing
test again. Operator only needs to press [SET] key, system can re-calculate imbalance value
with new data. Under interface showing imbalance value, press [SET] key to check current
inputted data of rim
8. Imbalance
optimize
If wheel imbalance value over 30 gram, system will be display “OPT”, indicate to carry out
