GB
16
Problem Possible
cause
Remedy
Tighten the screws. Check the
the device by Gloria Service.
Check whether the screws are
loose.
Abnormal sounds,
Shredder rattling.
Re-adjust the cutting plate (15)
as described in “Maintaining the
Cutting Cylinder”.
Cutting plate (15) not set
correctly at the cylinder.
Material to be chopped is not
severed sufficiently.
Use branches to eliminate
blockage. See chapter 6.2.
Cutting cylinder got stuck due
to too wet cutting material.
See chapter 5.6.
Turning direction has automati-
cally changed due to blockage.
Empy the collection container.
Collection container is over-full
(cylinder blocked).
Move the direction of rotation
switch (11) to the correct posi-
tion.
Aerator direction of rotation
is set incorrectly.
Shredder not accepting
material to be cut.
The motor can be switched on
again after 5 minutes.
Blockage protection activated
due to constant overload
or blockage at the cylinder.
Motor switches off.
Set the direction of rotation
switch to the desired position:
v
Material being cut is moved
upwards, e. g. if blocked.
b
Shredder setting.
Up / down switch set to
position 0.
Motor will not start.
The manufacturer warrants its
products for exclusively non-
commercial use for a period of
24 months from the date of orig-
inal purchase. This warranty
does not affect statutory warranty
Warranty
For portable units, which are
used outdoors, we recommend
to use a residual-current device
having a residual-current rating
≤
30 mA.
In Switzerland use of a residual-
current device is obligatory.
General
Faults usually occur if the unit
has not been handled, cared for
or maintained properly. The fol-
lowing table contains the most
common faults and remedies to
eliminate these faults. If you
have any other problems, please
contact your nearest service cen-
tre authorised by the manufac-
turer, or your nearest authorised
specialist dealer.
A
Caution! Repairs that
require specialist
knowledge must only be carried
out by an authorised specialist.
A
Caution! For safety reasons,
only use original spare
parts supplied by the manufac-
turer or parts that have been
authorised by the manufacturer.
We expressly point out that in
accordance with product liability
laws, we are not liable for any
damage caused by our units if
this damage is due to improper
repair or if parts exchanged are
not our original parts or parts
approved by us, and if the
repairs were not carried out at
service centre authorised by the
manufacturer or by an authori-
sed specialist. The same applies
to spare parts and accessories.
9. Faults
