Manual for
FP Board
16
A: The brightness of calibration screen can be adjusted by the Gamma value.
In order to get a bright screen, you can put the gamma value at 40. For dark green, you can set it at 100.
You can find this setting from the calibration software, “Operation”---“Parameter Settings—“Gamma Value”.
In order to decrease the interruption from ambient lights, our software will set the Gamma Value at 100 automatically after the
calibration.
5, Please touch in the center of the cross;
6
, To the sensitivity setting, Generally speaking it is from 2 to 5, it may cause the mouse out control if the sensitivity is too high (8), or
it may led writing is unable or broken if the sensitivity is too low, (such as 1 or 0);
7, To the function of right click of mouse, please press button for about 2 seconds. The target will become moving if jitter and it also
won’t pop up the context menu if the time is too short;
8, If it reported the software error when inserting the USB dongle, Please make sure the red light of the USB dongle keeps flashing,
or you can re-insert or other USB point ;
9, If there are time delay of green light In the red video of the calibration software
, please check the frame rate( open calibration
software-press video ) if less than 50, please change the computer to try or contact technicians;
10, Make sure the power of the fingers touch, please insert USB cable into the point of the computer chassis or please plug in the
power if it is a laptop
11, Q: After calibration, the mouse can be move but cannot do single or double click.
A: Check if there is Antivirus software in your computer, maybe the software prohibits the functions of mouse. Then just close the
Antivirus software.
12, Q: calibration screen is too dark to be clear.
A: P
lease open “Operation”-----“Parameter Settings”, put the Gamma value at a lower value—40. Please get it back to 75 or 100
after the calibration.
