1 Safety
4
Installation and maintenance instructions Energy 0020201109_01
▶
In order to operate the product, ensure that
the condensate siphon is always full.
1.4.3 Risk of death due to blocked or
leaking flue gas routes
Installation errors, damage, tampering, unau-
thorised installation sites or similar can cause
flue gas to escape and result in a risk of pois-
oning.
What to do if you smell flue gas in the prop-
erty:
▶
Open all accessible doors and windows
fully to provide ventilation.
▶
Switch off the product.
▶
Check the flue gas routes in the product
and the flue gas diversions.
1.4.4 Risk of death from escaping flue
gas
▶
Ensure that all openings in the air/flue pipe
that are within the building and can be
opened are always closed for start-up and
during operation.
Flue gas may escape from leaking pipes or
damaged seals. Mineral-oil-based greases
can damage the seals.
▶
When installing the flue gas installation,
use only flue pipes of the same material.
▶
Do not install any damaged pipes.
▶
File off sharp burrs and chamfer the ends
of the pipes before installing them, and
dispose of the shavings.
▶
Never use mineral-oil-based grease for the
installation.
▶
To facilitate the installation, use only wa-
ter, standard commercial soft soap or, if
required, the enclosed lubricant.
Mortar residues, shavings, etc., in the flue
gas route may restrict the outward flow of the
flue gas, meaning that flue gas can escape.
▶
After installation, remove all mortar
residues, shavings, etc., from the air/flue
pipe.
1.4.5 Risk of death due to explosive and
flammable materials
▶
Do not use or store explosive or flammable
materials (e.g. petrol, paper, paint) in the
installation room of the product.
1.4.6 Risk of death from electric shock
There is a risk of death from electric shock if
you touch live components.
Before commencing work on the product:
▶
Unplug the mains plug.
▶
Or disconnect the product from the power
supply by switching off all power supplies
(electrical partition with a contact opening
of at least 3 mm, e.g. fuse or line protec-
tion switch).
▶
Secure against being switched back on
again.
▶
Wait for at least 3 minutes until the con-
densers have discharged.
1.4.7 Risk of death due to lack of safety
devices
The schematic drawings included in this doc-
ument do not show all safety devices re-
quired for correct installation.
▶
Install the necessary safety devices in the
system.
▶
Observe the applicable national and inter-
national laws, standards and guidelines.
1.4.8 Risk of poisoning and burns caused
by escaping hot flue gases
▶
Only operate the product if the air/flue pipe
has been completely installed.
▶
With the exception of short periods for
testing purposes, only operate the product
when the front casing is installed and
closed.
1.4.9 Risk of being burned or scalded by
hot components
▶
Only carry out work on these components
once they have cooled down.
1.4.10 Risk of injury during transport due
to a high product weight.
▶
Make sure that the product is transported
by at least two people.
1.4.11 Risk of corrosion damage due to
unsuitable combustion and room
air
Sprays, solvents, chlorinated cleaning
agents, paint, adhesives, ammonia com-
pounds, dust or similar substances may lead
