German Light Products®
Installation
Fusion Stick FS16Z User Manual Rev. A
25
Suspending multiple fixtures vertically
To create a hanging vertical chain:
1. Suspend the first fixture as described in ‘Vertical suspension from a rigging
structure’ on page 23. Check that the installation will be safe and that the rigging
clamp and safety cable are approved for the total weight of all the fixtures in the
chain. If you intend to hang more than two fixtures, use M10 or M12 rigging eyelets
and cables to suspend the first fixture instead of a rigging clamp.
2. See Figure 12. Have two FS16Z Locking Pins
A
ready.
3. Lift the second fixture up to the first so
that the locking channels
B
in the fixtures
mesh with each other.
4. Push the two locking pins
A
into the
channels
B
in both fixtures. Press the
button on each locking pin so that you
can push the pin fully into its channel.
When the pin is fully engaged, release
the button and check that the button is
in the fully out position so that the pin is
locked in place. Check that the pins now
lock the two fixtures together.
5. If required by locally applicable
regulations, secure the second fixture by
using a safety cable to fasten the safety
cable attachment eyelets in the brackets on the back of the first and second
fixtures to each other so that the safety cable will catch the second fixture if it falls.
In some regions (where DGUV-215-313 is applicable, for example) the use of two
independent locking pins means that use of a safety cable is not required.
6. If you have suspended the first fixture using cables and rigging eyelets, you can
continue fastening fixtures to each other up to six (6) fixtures in total. If using fixed
rigging clamps, only two (2) fixtures may be linked.
Wherever possible, fix the bottom end of the fixture chain in place using cables or
other hardware to prevent movement which could cause damage to and failure of the
fixing at the top of the chain.
B
A
Figure 12. Locking pins used for
creating a vertical chain
Summary of Contents for Fusion Stick FS16Z
