www.glp.de
16
Highlander Wash Quick Start and Safety Manual
Mounting upright on a level surface
For upright installation on a stable horizontal surface,
fasten the floor stand shipped with the fixture to the
base. See drawings on right and below. The floor stand
mounts to the base with two Camlock quarter-turn pins.
Line up the Camlock pins with two Camlock sockets in
the base, then insert the pins fully and turn their handles
90° clockwise to lock.
See Figure 2. Slots are provided on the bottom of the
floor stand. To eliminate any risk that the fixture may fall
over during sudden head movements, pass a ratchet
strap through the slots and fasten it to a suitable
anchoring point.
Securing the fixture with a safety cable
In any location where the fixture can cause injury or damage if it falls, secure it with a
safety cable that is approved as a secondary attachment for the weight of the fixture.
To secure the fixture with a safety cable:
See illustration on right. Pass the
safety cable through one of the two
safety attachment eyelets
(arrowed) in the base of the fixture.
If the fixture’s floor stand is installed
on the fixture, do not use any part
of the stand for safety cable
attachment. If you do this, you will
leave the fixture unsecured.
Pass the safety cable through or
around a secure anchoring point
such as the truss or supporting
structure and take up as much slack
as possible, then lock the safety cable closed.
Check that the safety cable will hold the fixture safely if a primary attachment fails.
Figure 3. Safety cable attachment point
Figure 2. Strap attachment
points in floor stand
PRELIMINARY
Summary of Contents for Highlander Wash
