12
NOTE:
• These parameters can
ONLY be changed
in the setting mode.
• If the meter is idle for 3 minutes during the setting mode, it will switch
off automatically.
THE FOUR MEASURING MODES
The meter provides you with four modes for measuring, General, AC,
PC and QC. You can switch between each mode by:
1.
Start with the meter switched off. Insert a test strip to turn on the
meter. The screen will display a flashing “
” and “Gen”.
2.
Press
M
to switch between General, AC, PC and QC mode.
BEFORE TESTING
Calibration
You must calibrate the meter every time you begin to use a new vial
of test strips by setting the meter with the correct code. Test results
may be inaccurate if the code number displayed on the monitor does
not match the number printed on the strip vial.
How to Code Your Meter
(b)
Your GlucoRx Vet TD-4268 meter is supplied with two code strips.
There is one for cats, and one for dogs.
Please check your GlucoRx Vet TD-4268 meter with the correspond-
ing code strip for your pet to ensure proper performance.
1.
Insert the code strip when the monitor is off. Wait until the code
number appears on the display.
Congratulations! You have completed all settings!
Summary of Contents for TD-4268
