Part 1: Introduction
This guide covers:
Thermal CTP Plate Processor 150.
Reservations
•
This manual was written and illustrated using the best possible information
available at the time of publication.
•
Any differences between this manual and the equipment reflect improvements
introduced after the publication of the manual.
•
Changes, technical inaccuracies and typographic errors will be corrected in
subsequent editions.
•
As a part of our policy of continuous improvement, we reserve the right to alter
design and specifications without further notice.
This manual
Unintended use of the equipment
Glunz & Jensen A/S do not take any responsibility for any damage or accidents caused
by unintended use of the equipment:
•
As the equipment is certified by accredited test laboratory (UL International Demko
A/S) it is absolutely prohibited to make any modifications, electrical nor mechanical,
of the equipment. If however this prohibition is disregarded, Glunz & Jensen's
warranty will no longer apply and the certification labels for UL, C-UL, and CE
certification of the equipment shall be removed as the certification will no longer
apply to the equipment.
Intended use of this manual
•
This manual is for Service Technicians only and the directions given must not be
followed by unauthorized personnel.
•
Always read the
Safety Instruction Manual part No 21741
before installing or
operating the equipment and keep it with the machine for reference at all times.
1049
Installation Manual - Plate Processor 150
1-1
Introduction
This manual
