GLX LED STAGE 4 MANUAL
2
Thanks for choosing the GLX LED STAGE 4 lighting system. In order to make the best use of your LED
SYSTEM, please read the following carefully.
Important notes
1. Read these instructions.
2. Keep these instructions.
3. Do not use the LED STAGE 4 near water.
4. Clean only with dry cloth.
5. Install in accordance with the manufacturer’s instructions.
6. Do not block any ventilation openings.
7. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
8. Protect the power cord from being walked on or being pinched.
9. Unplug this apparatus when unused for long periods of time.
There are no user serviceable parts inside. All servicing has to be done by qualified service personnel.
Servicing is required when the LED STAGE 4 has been damaged in any way, such as when the power
supply cord or plug is damaged, when objects have fallen onto the LED STAGE 4, when it has been
exposed to rain or moisture, or when the LED STAGE 4 does not operate normally.
Warning: damages caused by the disregard of this user manual are not subject to warranty.
Installation of the GLX LED STAGE 4
Attach the LED BAR to the top end of a 35mm diameter stand and fasten the fixation screw making sure
the unit’s weight is evenly balanced. Please note: for overhead rigging in public or industrial areas, a
series of safety instructions have to be followed that this manual can only give in part.
Main connection
The device must only be connected in compliance with the IEC standards. The electric installation must
be equipped with a Residual Current Device (RCD) with a maximum fault current of 30mA. Lighting
effects must never be connected to dimming packs.
Operation
After you power up the LED STAGE 4, the LED’s start running and the display lights up. The device has
two operating modes; it can be operated in
sound controlled
or in
DMX-controlled mode.
You can choose the desired mode via the button
MENU, UP
and
DOWN
:
When the display shows
A***
you can choose the desired DMX address via the UP or DOWN buttons.
When the display shows
*512
the device is in DMX mode. To switch to sound controlled mode, press
the DOWN button.
When the display shows
*SND
the device is in sound controlled mode. To switch to DMX mode, press
the UP button.
When the display shows
S**
you can choose the desired speed of the internal programs. Default is 51;
for increasing speed press the DOWN button, for decreasing speed press the UP button.
DMX controlled operation
You can control the spots individually via your DMX controller. We recommend the GLX DMX-16 mixing
console.
DMX-512 connection
Only use a stereo shielded cable with 3-pin XLR-connectors in order to connect the controller with the
fixture or one fixture with another.
