The lower shock absorber mount can be moved to adjust the ground clearance. After
removing the two screws, the sleeve can be moved, move it down reduces the ground
clearance, move it to the top will raise it.
Make sure that suf
fi
cient space between motor and sleeve remains, to not affect the
fl
otation for best crawler ability.
RIDE HEIGHT ADJUSTMENT
9. Model Memory
The 3TD transmitter has 10 model memories, it is possible to store up to 10 models with all the settings in the trans-
mitter. To change the model memory,
fi
rst press the SEL key and then switch on the transmitter at the same time. You
can now switch between the model memories with the lever of the steering trim. Switch off the transmitter after
use.
8. Throttle Range (EPA CH2)
use this when performing forward and reverse angle adlustments. EPA adjusting value is between 5% and 120%.
Press the SEL-button 7-times for the left side adjustment (L.F.U), and 8-times for the right side adjustment (R.B.D).
Attention: Never attempt to allow it beyond 100%, because this would damage your servo. This setting affects both
steering servos, i.e. and the steering angle of the rear axle is set to the same value. T
he electronic speed controller
of the Punisher works only with a setting of 100% on both sides!
Forward
adjustment
Reverse
Adjustment
REMOTE CONTROL INSTALLATION
Insert the front servo connector to
channel 1 on the receiver.
Insert the ESC connector to chan-
nel 2 on the receiver.
Insert the rear servo connector to
channel 3 on the receiver.
When installing the components pay attention on a careful laying of all cables (power, motor cable), so it is maintained
that the full axle offset remains and the crawler will not stuck because of unsecured wiring. The best way is to use cable
ties and secure the wiring to the chassis or the chassis linkage.
17 GM-Racing 90140.RTR PUNISHER Crawler
Summary of Contents for Punisher Rock Crawler
Page 24: ...90140 RTR 43 GM Racing 90140 RTR PUNISHER Crawler ...
Page 28: ......
