License Plate Lamp
To replace one of these bulbs:
1. Reach under the rear bumper for the bulb socket.
2. Turn the bulb socket counterclockwise and pull
the bulb socket out of the connector.
3. Pull the old bulb straight out from the bulb socket.
4. Push the new bulb straight in until it clicks to
secure it.
5. Reach under the rear bumper to reinstall the bulb
socket into the connector.
6. Turn the bulb socket clockwise to secure it to the
connector.
Replacement Bulbs
Exterior Lamp
Bulb Number
Center High-Mounted
Stoplamp (CHMSL)
912
License Plate Bulb
W5W
Headlamps
High-beam
9005
Low-beam/Daytime Running
Lamp (DRL)
9006
Parking/Front Turn Signal
3757KA
Parking Lamp (Inboard)
3157A
Stoplamp, Rear Turn Signal,
Taillamp, and Back-up Lamp
3057
For replacement bulbs not listed here, contact your
dealer/retailer.
6-54
Summary of Contents for 2010 Canyon Crew Cab
