12
Inserting and removing bits
1. Select an appropriate bit and
Insert it into the hexagonal
hole in the chuck/bit retainer
(1). The screwdriver is now
ready for use.
2. To remove the screwdriver bit
you simply remove the existing
bit by pulling the bit out of the
chuck/bit retainer (1).
Maintenance
•
Store the tools, instruction manual and where necessary
the accessories in the original packaging. In this way you
will always have all the information and parts on hand.
•
If the cordset of the charger is damaged or worn, have it
repaired or replaced by an authorised service centre in
order to avoid a hazard.
•
Service to the tool should only be performed by qualified
repair persons using identical replacement parts. This will
ensure the safety of the power tool.
