13
12
If the air bubble is outside of the black circle, follow these recommend
adjustment steps:
•
It is important to check if the unit has been placed on a level surface.
The diagrams below illustrate the correct positioning of the unit.
•
If the unit is relatively flat, you can use the adjustment dial (4) to make
adjustment only on the vertical plane.
•
If the surface is not flat on a horizontal plain, you have a few options:
•
Use a flat piece of material (books, block of timber)
•
Use a tripod
Suggestion:
A tripod with an adjustable plate may be the best tool to use,
to ensure the self leveling vertical line generator is in a level position.
Caution:
Ensure the switch is in “0” position during adjustment.
Projecting Level Vertical Laser Line
When the self leveling
vertical line generator is
located in level position:
•
Ensure the laser
aperture (5) of the
tool faces the wall
which will be used for
projecting the laser
“chalk line”.
•
Switch on the self leveling vertical line generator, you will see the vertical
laser line swaying on the wall, whilst it automatically adjusts itself.
This process will take approximately 5 seconds where you will see
eventually a steady vertical laser “chalk line”.
•
Once the vertical laser “chalk line” has steadied, position the “chalk
line” to your target position.
