G - C O M B O
I N S T R U C T I O N M A N UA L
PA G E 1 9
3-4-9 Following a route
Often a trip from one place to another involves several course
changes requiring a series of route points (waypoints) which
you navigate to, one after another. The sequence of waypoints
leading to the ultimate destination is called a route. You
can save up to 100 routes and a route may consist of 100
waypoints.
Start Route Option
1 Press
PAGE
and select the
Chart
window.
2 Press
MENU
and select
Start Route.
3 Move cursor keys to select a route to start navigating.
4 Select
Forward
or
Reverse
to decide which direction you
want to navigate.
Route Window Option
1 Press
PAGE
and select the routes window
2 In the route window, move the cursor to highlight a route
you want to start navigating to.
3 Press
MENU
and select
start
4 Select
Forward
or
Reverse
to decide which direction you
want to navigate.
Create Route Option
1 Press
PAGE
and select the
Chart
window and
press
MENU.
2 Select
New route.
3 Name the route and present position.
4 Move cursor to a waypoint and press
ENT.
5 Move cursor to position of next waypoint and press
ENT.
6 Repeat step 5 to enter more waypoints.
7 Once last waypoint has been entered press
MENU
and
select
END.
To start route see 3-4-9.
Skipping a waypoint while following a route
1 Press
PAGE
and select the chart window.
2 Press
MENU
and select
Skip.
3 Repeat above step if necessary.
Cancelling a route
1 Press
PAGE
and select the
Chart
window.
2 Press
MENU
and select
Cancel route.
3-4-10 Goto Key
This key is very useful when you want to start navigating to a
destination point. When the key is pressed, it starts navigating
to the cursor.
Going to a point
1 Move the cursor to an open position.
2 Press
GOTO
3-4-11 Distance and bearing calculator
The unit can show the bearing and the length of leg and the
total distance of legs.
Setting Legs
1 In the chart window, press
MENU
and select
Distance.
Information is displayed in pop up window, showing
bearing/leg distance/total distance. This window will appear
in the bottom left hand side.
2 Move the cursor to the start point which is the start point of
the first leg and press
ENT.
3 Move the cursor to a point which is the end of the first leg.
4 Repeat 2-3 steps for more legs.
5 Press
ESC
to exit.
Deleting the last leg
1 Press
MENU
and select
Remove.
2 Repeat above step if you want to remove more legs.
Saving as a route
1. Once you set all the legs, press
MENU
and select
Save.
2 Enter a route name by pressing or to select a letter
then press for next letter.
3 Press
ESC
to save the new route.
Tip:
Bearing and distance
