GME G-DEK, Instruction Manual

G - D E K

  i n S t r u C t i o n   M a n ua l  

Pa G E   1 8

mute

Press the 

 button to temporarily silence the audio output. 

‘MutE’ will flash on the display to confirm the G-DEK has been 
muted and the speakers will remain quiet. Press the 

button again to restore the previously selected audio level.

Clock

the clock will normally be displayed whenever the G-DEK is 
switched off. to manually display the clock at any time, briefly 
press the 

 (display) button. after five seconds the display 

will automatically return to its original status. 

to adjust the time:

1. Press and hold the 

 button. the time will flash.

2.  turn the selector knob clockwise to adjust the minutes or 

counter clockwise to adjust the hours.

3.  When the correct time is displayed, briefly press the selector 

knob to store the time and return to the normal display.

the time can be displayed in either 12 hour or 24 hour mode. 
refer to the 

menu

 settings for details.

input source selection

Press the 

 button repeatedly to cycle through the G-DEK’s 

available input sources. the icon for the selected input source 
will be displayed. inputs include aM/FM tuner, SD card, uSB 
memory stick, auxiliary inputs 1 & 2, iPod and DaB tuner 
(GM550).

note: 

only input sources that are connected can be selected. 

the G-DEK will automatically skip over input sources that are 
not available (connected) e.g. if an SD card is not inserted the 
SD card source cannot be selected.

Whenever the G-DEK is switched on it will automatically 
attempt to return to the input source that was last selected.

RADIO OPERATION

am/Fm tuner

to select the aM/FM tuner press the 

 button repeatedly 

until the 

 icon is displayed.

Country selection

the G-DEK supports both European and uSa band settings. the 
settings control the different band edges and frequency tuning 

steps used by these countries (for details on frequencies and 
tuning steps see ‘Specifications’ at the end of this manual). 

When first connected, the G-DEK will default to the European 
setting which is compatible with most countries (including 
australia). For operation in the uSa, select the uSa country setting.

to switch between European and uSa band sets:

1.  While the radio is on, hold the 

 memory button while 

pressing the   button. the radio will display ‘Goodbye’ and 
switch off.

2.  Press the   button to switch the radio on again. ‘uSa’ or 

‘Europe’ will be displayed to confirm the selected band.

note: 

if all power is disconnected from the G-DEK, the unit will 

automatically return to the default European frequency bands.

band selector

there are three FM bands labelled FM1, FM2 and FM3 and 
two aM bands labelled aM1 and aM2. Each band has six 
station memories allowing you to store up to 18 FM and 12 aM 
stations. to step through the available FM and aM frequency 
bands press the 

 button repeatedly.