PA G E 1 0
i n s t r u c t i o n m A n uA l
G A 9 8 0 0
sPEcIFIcatIoNs
GeNeRAL
max . Power @ 2 ohm: 4 x 367 Watts
rms Power @ 4 ohm: 4 x 65 Watts
Bandwidth: 10 Hz – 40 kHz
signal to noise: ≥ 95 db
channel separation: ≥ 60 db
Input Sensitivity Range: 300 mV – 8V
LP Variable Crossover: 40 – 160 Hz & 12 dB/octave
HP Variable Crossover: 40 – 600 Hz/ 1 kHz &
12 db/octave
Variable Bass Boost: 0 – +18 dB & 45 Hz
Variable Subsonic Filter: 20 – 55 Hz & 12 dB/octave
Phase: no
rcA input model: yes
input impedance: 20 K ohm
Damping Factor: ≥ 200
T.H.D (4 Ohm): 0.05%
Fuse rating: 2 x 25 Amp
PHYSICAL
Dimensions: 254 mm (10”) (W)
x 56 mm (2.2”) (H)
x 381 mm (15”) (D)
*All specifications are typical and subject to change without notice or obligation
amPlIFIEr INstallatIoN
SUbWooFeR Remote control
PReCAUtIoNS
Before you drill or cut any holes, investigate your vessel’s
layout very carefully . take care when you work near the gas
tank, fuel lines, hydraulic line and electrical wiring.
Do not
operate the amplifier when it is unmounted . Attach
all audio system components securely within the vessel .
Do not
mount this amplifier so that the wire connections
are unprotected or in a pinched condition, or likely to be
damaged by nearby objects .
before making or breaking power connections in your
system, disconnect the vessel’s battery. Confirm that
your head unit or other equipment is turned oFF while
connecting the input jacks and speaker terminals .
lf you need to replace the power fuse, only replace it with a
fuse identical to that supplied with the system . using a fuse
of a different type or rating may result in damage to your
system which isn’t covered by the manufacturer’s warranty.
REMOTE
REMOTE
LINE CODE
