background image

GR350BT Quick Start Guide

Marine Bluetooth

®

 Radio

The full Instruction Manual can be downloaded from www.gme.net.au

INTRODUCTION

Congratulations on purchasing your compact AM/FM Marine Stereo with bluetooth. 
Your GME GR350BT Marine Stereo combines the very latest in electronic hardware and 
software, to produce an extremely compact entertainment system with innovative 
features and outstanding performance.

WHAT’S IN THE BOX

z

GR350BT AM/FM marine stereo

z

DC power lead

z

Mounting hardware

z

Speaker leads

z

Mounting template

z

Quick start guide

KEY FEATURES

z

Bluetooth streaming

z

4 X 40W Speaker outputs

z

USB/AUX inputs

z

Full-colour 69 cm (2.7”) TFT LCD display

z

Built-in AM/FM tuner

z

Water-resistant

INSTALLATION

CHOOSING A LOCATION FOR YOUR RADIO

The GR350BT is designed for in-dash mounting in an accessible position near your 
vessel’s steering position. Keep the following points in mind when choosing a location:

• 

Minimise excessive exposure to continuous rain or spray, excessive vibration 
or continuous direct sunlight.

• 

Allow room behind the radio to run the DC Lead to the power source.

• 

Allow a free flow of air around the heat sink at the back of the radio.

• 

To avoid interference with compasses, ships autopilot sensors etc., the 
GR350BT radio should be mounted at least 300 mm away from such devices.

1

5

Requires 

Bluetooth®

 2.1 or later.

The 

Bluetooth

® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and 

any use of such marks by GME is under license. Other trademarks and trade names are those of their 
respective owners.

 

Standard Communications Warranty against Defects

This warranty against defects is given by Standard Communications Pty 

Ltd ACN 000 346 814 (We, us, our or GME). Our contact details are set 

out in clause 2.7.

1. 

Consumer guarantees

1.1   Our goods come with guarantees that cannot be excluded under 

the Australian Consumer Law. You are entitled to a replacement 

or refund for a major failure and for compensation for any other 

reasonably foreseeable loss or damage. You are also entitled to have 

the goods repaired or replaced if the goods fail to be of acceptable 

quality and the failure does not amount to a major failure.

1.2   To the extent we are able, we exclude all other conditions, warranties 

and obligations which would otherwise be implied.

2. 

 Warranty against defects

2.1   This warranty is in addition to and does not limit, exclude or restrict 

your rights under the Competition and Consumer Act 2010 (Australia).  

or any other mandatory protection laws that may apply.

2.2   We warrant our goods to be free from defects in materials and 

workmanship for the warranty period (see warranty table) from 

the date of original sale (or another period we agree to in writing). 

Subject to our obligations under clause 1.2, we will at our option, 

either repair or replace goods which we are satisfied are defective. 

We warrant any replacement parts for the remainder of the period of 

warranty for the goods into which they are incorporated.

2.3   To the extent permitted by law, our sole liability for breach of a 

condition, warranty or other obligation implied by law is limited 

 

(a)  in the case of goods we supply, to any one of the following as we 

decide –

 

   (i)   the replacement of the goods or the supply of equivalent 

goods;

 

   (ii)   the repair of the goods; 

 

   (iii)   the cost of repairing the goods or of acquiring equivalent 

goods; 

 

(b)  in the case of services we supply, to any one of the following as 

we decide – 

 

   (i)   the supplying of the services again; 

 

   (ii)   the cost of having the services supplied again.

2.4   For repairs outside the warranty period, we warrant our repairs to 

be free from defects in materials and workmanship for three months 

from the date of the original repair. We agree to re-repair or replace 

(at our option) any materials or workmanship which we are satisfied 

are defective.

 

2.5   We warrant that we will perform services with reasonable care and 

skill and agree to investigate any complaint regarding our services 

made in good faith. If we are satisfied that the complaint is justified, 

and as our sole liability to you under this warranty (to the extent 

permitted at law), we agree to supply those services again at no extra 

charge to you.

2.6   To make a warranty claim you must before the end of the applicable 

warranty period (see warranty table), at your own cost, return the 

goods you allege are defective, provide written details of the defect, 

and give us an original or copy of the sales invoice or some other 

evidence showing details of the transaction.

2.7   Send your claim to:  

Standard Communications Pty Ltd.  

PO Box 96 Winston Hills, NSW 2153, Australia.  

Tel: (02) 8867 6000 Fax: (02) 8867 6199 

Email: servadmin@gme.net.au

2.8   If we determine that your goods are defective, we will pay for 

the cost of returning the repaired or replaced goods to you, and 

reimburse you for your reasonable expenses of sending your 

warranty claim to us. 

3. 

What this warranty does not cover

3.1   This warranty will not apply in relation to: 

 

(a) goods modified or altered in any way;

 

 (b)  defects and damage caused by use with non Standard 

Communications products;

 

 (c)  repairs performed other than by our authorised representative;

 

 (d)  defects or damage resulting from misuse, accident, impact or 

neglect;

 

 (e)  goods improperly installed or used in a manner contrary to the 

relevant instruction manual; or

 

 (f)  goods where the serial number has been removed or made 

illegible.

4. 

Warranty period

4.1   We provide the following warranty on GME products. No repair or 

replacement during the warranty period will renew or extend the 

warranty period past the period from original date of purchase.

PRODUCT TYPE

WARRANTY 

PERIOD

LAND AND MARINE 
ENTERTAINMENT SYSTEMS

1 YEAR

GENERAL OPERATION

CONTROLS

The diagram below details the operational controls of the GR350BT radio.

CH

MENU

CH

SRC

BND

MUTE

!"#$%

LCD Screen

Control Knob

(Rotate to scan;
Press to select) 

Tune Down (Radio) /
Previous Track (Media)

Tune Up (Radio) /
Next Track (Media)

Mute (Audio) /
Adjust Display Backlight

Pause/Play (Media) /
Select Band (Radio)

Next Pre-set

Broadcast Station

Menu / Return

Input Source Selection /

Power On/Off

Previous Pre-set

Broadcast Station

AM/FM RECEIVER OPERATION

The GR350BT has two AM bands, and three FM bands. 
The 5 frequency bands are labelled as AM1, AM2, FM1, FM2 and FM3.

To manually tune the radio to the desired frequency, briefly press the 

Tune Up

 or 

Tune Down

 button. 

To scan for stations automatically, press and hold the 

Tune Up

 or 

Tune Down

 button. 

BLUETOOTH OPERATION

Using Bluetooth®, you can stream A2DP audio directly to your radio.

Press the 

SRC

 button repeatedly to cycle through the radio’s available input sources. 

Alternatively, select 

Bluetooth

 from the menu.

To pair your smart phone, view the list of available Bluetooth® devices (some devices 
require you to tap 

Scan

 to populate the list). Select ‘GR350BT’ when it appears on the 

list.

NOTE

: The GR350BT radio supports music streaming only. It does not support making 

or receiving calls.

MULTIMEDIA OPERATION

The GR350BT radio can play a variety of multimedia files music / movies / photos directly 
from a USB memory drive up to 16GB in size.

Drawing No: 51154-1  Part No: 311115

Standard Communications Pty Ltd trading as GME.
Head Office: 17 Gibbon Road, Winston Hills NSW 2153, Australia 
Australia. New Zealand: PO Box 58446 Botany, Auckland, 2163, NZ. T: (09) 274 0955.
All international enquiries email: wpexport@gme.net.au

gme.net.au

PRINTING SPECIFICATIONS:

 GR350BT QUICK START GUIDE

Dimensions: 329 X 178 Folded Twice To 110 X 178 
Stock:  

130 GSM Satin Art Both Sides

 

Print: 

CMYK Throughout

Finish: 

Folded to size

Part Number:

 311115    

Drawing Number:

 51154-1 

ARTWORK SUMMARY 

DRAWING #

51154-1

PART #

311115

JIRA REFERENCE

TECHDOCS-37

ECO #

N/A

SUPPLIER

VELEX

MPE #

Reviews: