PA G E 8
i n s t r u c t i o n m A n uA l
r c 9 0 0 B t
RADIO OPERATION
country Selection
When power is first applied, the RC900BT will
default to the European frequency bands. to toggle
between European and usA band sets:
1. Press and hold the memory ‘3’ key AND press the
power
key.
2. The radio will display ‘Goodbye’ and switch off.
3. switch the radio on again using the power key.
usA or Europe will be momentarily displayed to
indicate the selected band.
NoTe:
if all power is disconnected from the
RC900BT, the unit defaults to European frequency
bands when reconnected.
NoTe:
the differences between bands is listed in
the specifications at the rear of the manual.
10
Band Selector/phone answer
To select the required radio band (MW1, MW2,
FM1, FM2 or FM3), sequentially press the
BND
button until the required band is selected.
11
Tuning/Selecting Tracks
Manual Tuning
To tune the radio manually, momentarily press the
or
button to select the desired frequency.
Press
to tune up or
to tune down.
automatic Tuning (Seek)
Press and hold either the
or
buttons for
1 second. the rc900Bt will stop seeking when a
strong, clear station is detected.
Storing of Stations in Memory
Once the desired station has been selected, press
and hold one of the six preset station memory
buttons on the front panel for 1 second. the
corresponding button number will appear on the
lcD indicating that the selected station is now
programmed into the rc900Bt memory.
13
auto programming of radio Stations
(aMS)
Select the required band
Press and hold the
aMS
button for 1 second.
the rc900Bt will commence searching the band
for radio stations. As each station is located it is
automatically stored in the next available preset
memory location. the new stations will replace any
stations previously stored in that band.
14
Scan
In the TUNER mode, press and hold the
ScaN
button for 1 second. the rc900Bt will scan the
selected radio band for all available stations,
pausing briefly at each to let you decide whether you
wish to listen to this particular station. To exit the
Scan mode, press the
ScaN
button again.
Manually Selecting the preset Station
Memories
Briefly press the desired station memory
1- 6
. the
RC900BT will jump immediately to that station and
the memory number will appear on the lcD.
CD/MP3 OPERATION
WarNiNg:
Do not insert cDs containing
anything other than standard audio or Mp3
files into the disc slot.
the cD mechanism
contains precision laser components which could
easily be damaged by inserting foreign objects.
iMporTaNT:
Because of the wide dynamic range
offered by CD systems, the difference in volume level
between very soft sounds and very loud sounds can
be quite high. For this reason we recommend that
you avoid turning the volume level up too loud when
listening to very soft music or tracks with no audio
level otherwise a sudden change to very loud music
could damage your speakers.
inserting the cD
Remove the CD from it’s case and insert the disc
label-up into the front panel aperture. The CD
mechanism will automatically draw the disc into
the player and start playing track 1.
label side up
