background image

PAGE 4 

INSTRUCTION MANUAL 

 

 SOUND SAFE

Pick up / Hang up

When there is a incoming phone call, press the button to receive the call. To hang up at any time 
during the call, press the button.

Microphone Sensitivity

For optimum performance, the microphone should be facing towards you at a distance of no 
more than 40 cm.

Play / Pause

You can control the music play or pause by pressing the play/pause button once. Press the  
button to start music playing. While the music is playing, press the button to stop/pause music.

FWD/RWD (‘I’ mode only)

When the ‘I’ mode is selected, you can use the button to fast forward or rewind the current song. 
Press the button twice to fast forward the song. Press the button 3 times to rewind the song.

care, maIntenance and precautIons

1.   Although the product is waterproof, it is NOT 

designed for use under water. Do NOT intentionally 
submerge the unit.

2   Close both safety latches properly before use, as 

shown in Fig.4. If the unit is not correctly closed,  
water may enter the battery compartment and void 
your warranty.

3   Do NOT open the unit when wet or in a wet 

environment. Dry the unit completely before opening.

4   Do NOT use or store the unit in high temperature environments (eg: directly exposed to 

sunlight for long periods or in a closed car, etc.) significant altitude/temperature change or 
strong magnetic fields.

5   Always check the rubber sealing ring is properly seated and that there is no dirt, hair, sand, 

audio wires or particles in the way.

6   Always clean the rubber sealing ring with a soft moist cloth before use. Do NOT use any 

oily solvent or chemicals for cleaning as this

 

may cause the rubber sealing ring to degrade 

causing the Sound Safe to lose its waterproof properties.

7     If used in or around salt water, rinse with fresh water and wipe with a soft moist cloth after 

each use.

8.   Do NOT mix new and old batteries or rechargeable and non-rechargeable batteries.

9   Alkaline batteries are recommended. Always remove the batteries if the unit will not be used 

for a long period of time.

10   Noise and audio distortion may occur when the batteries are old. Replace the batteries with 

new alkaline batteries or fully charged rechargeable batteries.

11.  For best audio performance always ensure the SELECTOR switch (below the battery 

compartment) is properly set to suit your audio device. If distortion occurs, try switching 
between the ‘I’ and ‘S’ settings to determine the best selection for your audio device.

Fig. 4

Summary of Contents for SS002B









Reviews: