PA G E 1 2
I n s t r u c t I o n m A n uA l
t X 3 5 1 0 / t X 3 5 2 0 / t X 3 5 4 0
Your radio allows you to enable or disable Duplex mode
on individual repeater channels. In this way any repeater
channels that are not being used with repeaters in your area
can be used in simplex mode for normal direct radio-to-radio
communications.
Channel Selected
Receive Channel
Transmit Channel
1
1
31
2
2
32
3
3
33
4
4
34
5*
5*
35*
6
6
36
7
7
37
8
8
38
41
41
71
42
42
72
43
43
73
44
44
74
45
45
75
46
46
76
47
47
77
48
48
78
*Emergency channel only
To enable Duplex on a Repeater channel
1. select the required repeater channel (1-8, 41-48).
2. Briefly press the
DUP
key. the duplex symbol
will
appear on the display accompanied by a high beep.
To remove Duplex from a Repeater channel
1. select the required repeater channel (1-8, 41-48). If
duplex is currently selected, the
duplex symbol will be
displayed.
2. Briefly press the
DUP
key. the duplex symbol
will
disappear from the display accompanied by a low beep.
IMPORTANT:
channels 1-8, 31-38, 41-48 and 71-78 should
only be used in simplex mode if there are no repeaters in or
near your location that operate on the selected channel. In
particular, avoid operating in simplex mode on any of the
repeater input channels 31-38 and 71-78 unless you are
absolutely sure that there are no repeaters in range using that
channel. Inadvertently transmitting on an active repeater input
frequency in simplex mode could cause interference to other
users on that repeater that would not be audible to your radio.
PRIORITy CHaNNEL
the priority channel feature allows you to instantly recall any
one of the 80 channels in your radio. this feature can be used
to provide instant access to your working channel or your
local repeater channel at the press of key. It is also used in
conjunction with the Group scan mode.
To store a Priority channel
1. select the required channel.
2. Briefly press
F
then press and hold the
Channel knob
(or
LVL
PRI
key). the channel number will flash then a high beep
will be heard as the channel is stored.
To recall a Priority channel
1. Briefly press
F
then briefly press the
Channel knob
(or
LVL
PRI
key). the radio will immediately switch to the priority
channel and PrI will be displayed for a few seconds.
NOTE:
If the radio was scanning when the priority channel
was recalled, the scan will be cancelled.
