SECTION 5 MAINTENANCE
5.11
*
eneral
Observe and Obey:
D
Only routine maintenance items specified in this manual shall be performed by the operator;
E
Scheduled maintenance inspections shall be performed by qualified service technicians, according
to the manufacturer's specifications and the requirements listed in the responsibilities manual;
F
Disposal of materials should be according to the regulations of government and relevant
environmental protection administration;
G
Use only
*0*
approved replacement parts.
*0*
assumes no responsibility for
hazards
occurred to equipment and personnel caused by the use of unauthorized parts.
5.1.1 Maintenance symbols legend
The following symbols have been used in this manual to help communicate the intent of the instructions.
When one or more of the symbols appear at the beginning of a maintenance procedure, it conveys the
meaning below:
Indicates that tools will be required to perform this procedure.
Indicates that new parts will be required to perform this procedure.
Indicates that a cold engine is required before performing this procedure.
5.1.2 Pre-Start inspection
D
Be sure operator's, safety, and responsibilities manuals are complete, legible, and in the storage
container located on the machine;
E
Be sure all decals are
in place and legible;
F
Check for hydraulic oil leaks and proper oil level. Add oil if needed.
See Maintenance section;
G
Check for battery fluid leaks and proper fluid level. Add distilled water if needed after battery
charged;
H
Check the following components or areas for damage, improperly installed, or missing parts and
unauthorized modifications:
Electrical components, wiring, and electrical cables;
Hydraulic hoses, fittings, cylinders, and manifolds;
$-(%RRP/LIW2SHUDWRU¶V0DQXDO
3DJH
