BT BENCH ASSEMBLY INSTRUCTIONS
Insert the lower portion of the adjustable
height leg into the top portion of the leg.
The lower insert has pre-installed nuts
that will line up with two holes in the
upper section of the leg assembly.
Secure the two pieces toghether at
the desired height using
(2) 1/4-20 x 3/4” Flange head bolts
per lower insert.
STEP 2
If purchased attach the lower shelf:
Lean one end of the shelf onto a leg. Hand start
bolts into the 4 threaded inserts.
Use (4) 1/4-20 x 3/4" flange bolts.
Set the opposite end of the shelf onto the
second leg. Hand start 4 bolts to attach shelf
to the second leg. Do Not fully tighten.
Use (4) 1/4-20 x 3/4" flange bolts.
TOOLS REQUIRED FOR ASSEMBLY
Socket set, Open end wrench set, Cordless drill with
3/8" socket bit (Magnetic recommended).
BEFORE ASSEMBLING THE WORKBENCH
Assembly of this bench will require 2 people.
Read through the assembly instructions to
familiarize yourself with the order in which the
parts are assembled. We suggest that you clear
& vacuum the area where the bench is to be
assembled. It is important that the bench is
assembled in the same sequence as instructed.
HARDWARE
All assembly hardware is provided.
1/4-20 x 3/4”
Flange Head Bolt
Attach caster to the bottom leg insert plate
using (4) 5/16-18 x 1” hex head bolts,
(8) washers, and (4) nylock nuts.
STEP 1
**SKIP THIS STEP IF YOU HAVE NOT PURCHASED THE CASTER OPTION**
MOBILE CASTER KIT OPTION
Nylock Nut
5/16-18 x 1”
Hex Head Bolt
5/16” Washer
x2
STEP 3
1/4-20 x 3/4”
Flange Head Bolt
