SRE-200 INSTRUCTOR STATION
TOOLS REQUIRED FOR ASSEMBLY
Cordless drill with phillips head Bit & magnetic extension,
3/8" Magnetic socket bit.
BEFORE ASSEMBLING THE WORKBENCH
Read through the assembly instructions to
familiarize yourself with the order in which the
parts are assembled. We suggest that you clear
& vacuum the area where the bench is to be
assembled. It is important that the bench is
assembled in the same sequence as instructed.
HARDWARE & GMI COMPONENTS
All assembly hardware is provided. Full size photos
accompany each step where hardware is needed.
STEP 1
STEP 2
Place the two tops on the assembled base.
Adjust until it matches the view to the
right. Attach the two tops via the connector
plate using (10) #14 x 1” Lag screws.
Attach the top to the bases. Position the top
as shown in the image. (You must
remove the top drawer(s) from drawer
cabinets).
Use #14 x 1" Lag Screws. (4) for each
cabinet and (9) for the leg pedestal.
Attach the modesty panel to the base cabinets and
corner pedestal. Layout as shown in the top view.
Use (2) 1/4-20 x 1/2" Bolts for each end of the
modesty panels (8 total). Hand start all bolts or
you may strip the threaded insert.
1" Front
1" Left Side
Modesty Panel
Top View
Fig.1
5" Spacing
