CONTROL PANEL
D. "PAPER LENGTH"(Button to set up Paper Length) :
To set up the length of substrate.
Length set up range for MANUAL MODE is "203 ~ 1,219"mm and for ATUO MODE is "254 ~ 813"mm.
☞ How to set up Substrate Length
: Press "PAPER LENGTH" button and set up a required length with MASTER DIAL. Setting value is saved
after 5 secs. automatically.
NOTE
: This product has "UNDERLAP" cutting system. Then, setting value has to be smaller than real size by 3~5mm for underlapped area.
E. "SPEED"(Speed Setting Button) :
To set up the laminating speed. Speed setting range is "1 ~ 15".
☞ How to set up Speed
: Press "SPEED" button and adjust speed with MASTER DIAL.
F. "JOB"(Job Mode Selection Button) :
Save regularly used job conditions at the memory to avoid reset the conditions in future.
Job mode is composed of 13 kinds (Poly-L~User3).
☞ Select a Job Mode
: In stop status, press "JOB" button and select a required job mode for films with "MASTER DIAL".
Temp., Substrate length can be saved by operator and this value is saved automatically after 5 secs.
☞ Other functions of "JOB" button
: Press JOB button for 3 secs., mode can be changed to SINGLE or to DUAL mode.
"DUAL" mode is required in PROTOPIC III-540DUAL to heat up the Embossing Roller.
NOTE : Factory Setting Progress
In "Poly-L" Mode, press "TEMP" button and "STOP" button at the same time, message of "Factory Setting Progress Waiting" is blinking and displaying
for around 15 secs. After on, the setting value in JOB mode is changed to Factory Setting Values.
G. "BURST POSITION"(Set up button for the Bursting Point) :
To set up operation point of Bursting Roller. Bursting Point range is "960 ~ 1060"mm
☞ How to set up Bursting Point
: Press "BURST POSITION" button and set up its position with MASTER DIAL. The set value is saved automatically after 5 secs.
NOTE
: Characteristics of materials / thickness, height of decurling bar, laminating speed make bursting point change, then, adjust it for its cutting status.
Basically, the range is "960 ~ 1060"mm
15/51
