HOW TO USE CONTROL PANEL
③ "B:100℃W - Bottom Roller Temperature & Condition Display Window
It displays Bottom Roller Set Temp. and Current Temp.
NOTE : "W"(WAIT) or "R"(READY) means "Working Wait" or "Working Ready".
- "W"(WAIT) : Current condition is not suitable for lamination. (Temp high or low)
- "R"(READY) : : Current condition is suitable for lamination. Start operation.
④ "L:0315" - Paper Length Display Window
It is to show the paper length. Refer to 'PAPER LENGTH' in each function for paper length setting.
⑤ "SPD:03" - ller Speed Display Window
It is to show the rotating speed of laminating roller. Refer to 'SPEED' in each function for speed setting .
NOTE : Start the lamination at the low speed for initial job.
⑥ "B:1000" - Bursting Paper Timming Display Window
It shows starting time of Bursting Roller. Refer to "BURST POSITION" on display for burst position setting.
⑦ "C:00010" - . Counting Paper/
Roller Heating Mode Display
It shows the laminating number for some period of time. The initial reset is possible when necessary.
☞ Counter Reset : Push "SPEED" and "MASTER DIAL", Or turn off and on power.
Then, counter will be reset, but previous data will not be saved.
☞ Roller Heating Mode Display
Theres are "SINGLE" Mode and "DUAL" Mode. Under "SINGLE" Mode, bottom roller will not be heated, even though you set the temperature.
NOTE : Refer to "TEMP" on display for changing Mode and detailed operation.
⑧ "MAN" - Feeding Paper Display Window
It shows how to feed paper. Theres are two modes, "MAN"(Manual) and "AUTO"(Automatic) Mode.
Refer to "MASTER DIAL" on display for changing method of feeding paper.
⑨ Error Message Display :
When error will be happened, it shows if you run motor. At this time, the laminator will not run.
NOTE : Refer to "ERROR MESSAGE' to be displayed.
18/51
