HOW TO USE CONTROL PANEL
"BURST POSITION"
To change Bursting Position.
Bursting Position Setting Range is Min. "580" ~ Max. "660".
NOTE : How to set substrate length is the same as how to set speed in "SPEED" menu.
It saves automatically 5 seconds after set up.
"TEMP"
To adjust temperature on TOP ROLLER.
Temp. Adjustment Range is Min. "0" ~ Max. "150".
While the system is stopped, if the TEMP BUTTON is pressed for more than 3 seconds, DAILY COUNTER is reset.
When the LED is on, top temp. control is available.
On status of LED ON, if temp. button is pressed, you can control bottom temperature.
NOTE : How to set substrate Temp is the same as how to set speed in "SPEED" menu.
"BURST ON/OFF"
To operate / stop Bursting.
If the button is pressed during lamination, Bursting is ON(operation) and bursting roller starts to move up/downwards.
If the button is pressed again, it turns to stop(OFF) and bursting roller is stopped.
NOTE : If the system is in stop status, the button is not activated. Then, the button can be activated only
in system operation status.
18/60
