HOW TO USE CONTROL PANEL
"BURST H/L SPEED"
To increase the burst motor speed by 20% faster.
If the button is pressed : MOTOR HIGH SPEED
If the button is not pressed : MOTOR LOW SPEED
While the system is stopped, if the BRST H/L BUTTON is pressed for more than 5 seconds, heating mode is changed.
NOTE : Apply the above condition to laminate "NYLONEX(Nylon base)","PERFEX(PET base)" films.
"TABLE(UP/DOWN)"
To make the Feeding Table "UP" or "DOWN".
If the "DOWN" is selected, the feeding table goes down and while the "UP" is pressed, the feeding table goes up.
NOTE : While the "UP" is pressed, the feeding table is operated and the button is not pressed,
the operation is stooped.
NOTE : If the Feeder would not be at the Ready position, the feeding table cannot go upside.
-> Select the "FEEDER HOME" and take the Feeder at "Origin" Position.
"TABLE STOP"
To stop table motor.
19/60
