GMX Mini e-Quad, Assembly Manual

CHARGING THE BATTERY

The charger has a small window with one LED or two LEDs to indicate the charge status. The charging port in located under 

the seat. Place the charger in the socket ensuring a tight fit. Place the charger in the wall socket. 

This will illuminate green until you switch the power on the wall socket. It will then illuminate red indicating it is charging 

and green once charged.

ASSEMBLY GUIDE

Do not store the battery in temperatures above 75° F or below -10° F.

                                      CONTAINS SEALED NON-SPILLABLE LEAD BATTERIES. BATTERIES MUST BE RECYCLED.

Disposal: Your GMX product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally 

sound manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not dispose of a 

lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed lead-acid batteries 

with household trash is prohibited by law in most areas. Return exhausted batteries to a federal or state approved 

lead-acid battery recycler or a local seller of automotive batteries.

Problem

Possible Cause

Solu

ti

on

Motorbike does not run        Undercharged ba

tt

ery

Charge the ba

tt

ery. A new ba

tt

ery                        

Should be charged for at least 18 hours before using the motorbike 

for the 

fi

rst 

ti

me and up to 12 hours a

ft

er each subsequent use.

Check ALL wires and connectors. Make sure the charger connector 
is 

ti

ghtly plugged into the charging port, and the charger is plugged 

into the wall

Make sure the power point is turned on

Loose wires or connectors

Check all wires and connectors to make sure they are 

ti

ght. The 

fuse will burn out and automa

ti

cally shut o

ff

 the power if the 

power if the motor is overloaded.

Motorbike was running
but suddenly stopped

Burned-out fuse

An excessive overload, such as too heavy a rider or too steep a hill,
could cause the motor to overheat. Replace the fuse with a new 
one of equel amperage. Correct the condi

ti

ons that caused the 

fuse 
to burn out to avoind burning out the fuse again.

Motor or electrical switch damage

Contact GMX service centre for diagnosis and repair 

Short run 

ti

me (less than

15 minutes on full charge)

Undercharged ba

tt

ery

Charge the ba

tt

ery. A new ba

tt

ery                        

Should be charged for at least 18 hours before using the motorbike 
for the 

fi

rst 

ti

me and up to 12 hours a

ft

er each subsequent use.