10
Warning
. Any servicing or maintenance work carried out by an unauthorised person will
invalidate the manufacturers warranty and could result in a dangerous situation.
Installing the appliance
It is a legal requirement that all gas appliances are installed by competent persons qualified in
accordance with the local and national regulations (GasSafe registered in the UK). Failure to
install the appliance correctly could invalidate any warranty or liability claims and lead to
prosecution.
The appliance shall be installed in accordance with the local and national/European standards in
force. Particular attention shall be given to the requirements regarding ventilation.
This appliance may not be installed in a room containing a bath or a shower.
Read these instructions before installing or using the appliance.
Ventilation
This appliance is suitable for installation into boats, recreational vehicles and caravans. The
national standards regarding ventilation must be adhered to.
The use of this cooker results in the production of heat and moisture in the area in which it is
installed. Ensure that the galley is well ventilated. Keep natural ventilation passages open or
install a mechanical ventilation device.
Loose items supplied with cooker
(Qty / Description)
1 Instruction book
1 Oven wire shelf
2 Oven frames
1 Grill deflector
1 GN ½ pan
1 GN ½ wire trivet
8 (4 / 6) Pan fiddle clamps (depending on
model)
4 Sea Rails (1 front rail (low height), 3 side
and back rails)
1 1.5V Battery size AA
2 Gimbal pivot brackets
1 Harbour lock bracket
1 Counterweight (if not supplied fitted)
Positioning the cooker
A horizontal distance of 200mm must exist between the edges of the appliance and any
combustible material unless that material is protected by a layer of non combustible material. All
combustible material such as curtains and shelves must be kept well clear of the appliance. Any
fittings such as a cupboard above the cooker must have a minimum clearance of 500mm between
the fitment and the top of the pan support.
Installation for Gimballing
The cooker is designed to be installed into a ‘cooker box’ sited between two vertical walls using the
the two gimbal mounting plates fitted to appropriate wooden blocks held using M6 bolts or screws.
The cooker is set up to fit into a 485mm gap.
1. To install:
2. Use the diagram below to establish the relative positions of the gimbal pivot facing bracket and
harbour lock facing bracket (on left wall).
3. Identify a suitable position to mount the left and right hand gimbal pivot and the harbour lock
facing bracket.
4. The gimbal and harbour lock facing brackets should be located in such a position to allow the
cooker to gimbal perpendicular to the vertical furniture walls and also to be horizontal plane.
