Page 14 of 18
Doc. no. 0072930 rev. F
Final assembly
NOTE :
When replacing the PCB,
remember to place the same
ID part No. in the new socket
holder.
Using the applicable fixture, solder the
Receiver wires from rec. Module to the
electronic module. Do not strain the
Wires.
While routing the rec. wires, fit the
electronic module to the receiver
Module. Ensure the wires are not
trapped between the two modules.
Fit the battery door to the
receiver module and fix it
with the pin.
Insert the on-off mechanism into the
device. Ensure it is seated correctly
in the housing.
Insert the ID part (printed w/
Serial no.) into socket holder
and secure correctly.
