800-350-8739
MBRPMM106H Rev. A.1
Page 4
www.braveproducts.com
800-350-8739
3. ASSEMBLY INSTRUCTIONS
(MIXER STANDING ON END)
1.
Fully unpack unit, cut straps, remove all cardboard, plastic wrap and all protecting
packing material from unit.
You will see:
•
(2) Wheels
•
(1) Axle assembly with speed hubs and wheel lugs bolted
on
•
(1) Idler spring attached into axle tab
•
(1) Towing hitch with quick pin and a hex bolt with nut
•
(1) Dumping lever zip tied in the inside of the drum with
hardware installed but not tight.
2.
Once the mixer is unpacked proceed to attach the mixer’s axle making sure that the axle
spring tab lines up with the mixer frame hole on the engine base of the machine.
3.
Proceed to fasten axle to mixer frame using appropriate tools. Tighten to 57 ft. lbs.
4.
Once mixer axle is fastened, hook both ends of idler spring, the rounded end to the
farthest out hol on axle and the oval end to the idler pulley (clutch) on the inside of the
engine base.