8
4.
Remove the
rolling frame / seat assembly
from the travel
case and place it, again, on a raised, flat surface such as a bed or
table, with the legs facing up.
5.
Decide
whether
you
want
to
mount
the
20”-
diameter wheel assemblies
ON THE FRONT SET OF
LEGS OR ON THE REAR. This
decision is strictly a matter of
personal preference and will
affect
neither
safety,
performance nor any other
feature of your GO-Anywhere
Chai
r™.
6.
Install the first
20”-
diameter
wheel
assembly
(removed from the case in step
1), by depressing the spring pin
button on the leg extension of
the
20”-diameter
wheel
assembly
and lowering the leg
extension down, and into, any one of the
four open-ended legs.
7.
Repeat the previous instruction with
the second
20”-diameter wheel assembly
installing it into the open-ended leg
opposite the first.
8.
Remove both
legs with swivel
casters
from the
accessory pouch
.
There
are left and right caster legs
. Install
them, ensuring that the colored dots
on the lower legs match those on the
upper legs (so the exposed bolt
heads at the bend in each leg face
outwardly from the chair).
