11
STEP 3
:
Attach the Upright Tube Assembly to the Base Frame
NOTE: This step is easier to complete with 2 people
!Caution Pinch Point: Do not pinch the wires between the frame!
(A) Hold the upright tube over the round base fram tube so that the data
cable can be connected prior to assembly
(B) After the data cable is connected slide the upright tube onto the round
base frame tube.
(C) Check to make sure the upright tube is facing the correct direction.
(See Fig.3 A)
(D) Secure the upright tube to the base frame by using 6 x #18 Allen head
bolts.
(E) Hand tighten all the bolts first, then completely tighten the bolts near
the label marked 1 with the Allen wrench. (See Fig. 3B)
(F) Now completely tighten all bolts with the Allen wrench.
(G) Place the left and right upright tube covers #118A/118B around the
upright tube and secure them by using 4 x #115 screws(See Fig. 3C)
#115
4
Facing towards the
back of the machine
Fig 3A
Fig 3B
Fig 3C
