13
STEP 5
:
Attach the Console Base and Handlebars
(A) Place the console base on top of the upright tube and align the bolt
holes (See Fig. 5A)
(B) Secure the console base to the upright tube by using 3 x #18 Allen
bolts. Completely tighten the bolts now
(C) Attach the console base covers #113A and 113B around the console
base and secure the covers together by using 4 x #29 screws and
4 x #30 screws. (See Fig.5B) Do not completely tighten these screws
until step 6
(D) Feed the Heart rate wire of the hand grips through the small hole
below the handlebar bracket then up through the top of the upright
tube. Lay the wires over the top of console base covers
(E) Attach and secure the handle bars to the handle bar bracket on the
upright tube by using 2 x #6 Allen head bolts. Completely tighten the
bolts (See Fig 5C)
#18
3
#29
4
#30
4
#6
2
Fig. 5A
Fig. 5B
Fig. 5 C
