Note: Completely read instructions before beginning installation!
1. Remove the contents from the box and check for missing pieces or damage. If parts are missing or damaged, contact the original place of purchase.
2. Remove the bumper cover by following the steps listed below:
A. Remove the plastic push clips on top to free the upper section of the bumper cover.
B. Remove the hex bolts from the bottom of the bumper.
C. Remove the push clips on each side that attach the bumper to the inner fender.
D. Remove the hex bolts in the lower front wheel well area.
E. Remove the factory hex bolts on both sides that hold the bumper cover to the fender. To access and remove the hex nut you will need to
push aside the inner fender.
F. Unplug the side marker lamp.
G. With the help of another person slowly pull the bumper cover off and be careful not to damage the cover.
3. Once the bumper reinforcement is exposed, remove the (8) factory bolts that hold the bumper reinforcement to the crash canister. Once the (8)
factory bolts are removed, drill out the spot welds above and below the bumper reinforcement on each side. Diagram 4,5 & 7. Use a pry bar to separate
the bumper reinforcement from the crash canister enough to slide the bracket in between the bumper reinforcement and the crash canister as seen
in Diagrams 3 and 4. Please note that the plastic air deflector will need to be trimmed for bracket clearance. Reference Diagrams 4 and 5 for areas to
trim. Make sure the bracket is lined up with the (2) holes on the bumper frame and replace the (8) factory bolts as shown in Diagram 6 (Page 2). The
mounting holes in the brackets are slotted for up and down for adjustability. It is recommended for initial fitting to place the brackets in the furthest
upward position and make adjustments if needed.
Passenger view of air deflector trimming
Driver view of air deflector trimming
Diagram 4
Diagram 5
Area to trim
Area to trim
Pry apart
Pry apart
Bumper
Reinforcemen
t
Bumper
Reinfor
cemen
t
Parts List:
1 - Police Grille
Guard
1 - Driver Bracket
#38017-5
1 - Pass. Bracket
#38017-6
6 - 1/2” x 1 1/2”
Bolts
6 - 1/2” Hex Nuts
6 - 1/2” Lock
Washers
12 - 1/2” Flat
Washers
Diagram 1
Diagram 2
38017
40017
Thank you for choosing Go Industries’ products. For additional installation
assistance, please call Technical Support (800) 527-4345 or (972) 783-7444
Page 1 of 2 pages 01/15
Enforcement Series
Grille Guard
Installation Instructions
38017 / 39017 / 40017
Dodge Charger ‘15
420 N. Grove, Richardson, TX 75081
Tele: (800) 527 - 4345 Fax: (800) 442 - 5263
Web site: www.goindustries.com
E-mail: gosupport@goindustries.com
39017
Diagram 3
Drill Weld
Drill Weld
