58647W Components
1) 58647W Pro-Series Bumper Replacement
1) Driver side mounting bracket #59647-5
1) Passenger side mounting bracket #59647-6
2) Bracket for 6” light #59645-11
1) Hardware Kit #59645KIT
Thank you for choosing Go Industries’ products. For additional installation
assistance, please call Technical Support (800) 527-4345 or (972) 783-7444
Page 1 of 2 pages 3/17
420 N. Grove, Richardson, TX 75081
Tele: (800) 527 - 4345 Fax: (800) 442 - 5263
Web site: www.goindustries.com
E-mail: gosupport@goindustries.com
59645KIT Hardware Kit Contents
20) 1/2” - 13 x 1 1/2” Hex Bolts (silver zinc)
40) 1/2” Flat Washers (silver zinc)
20) 1/2” Nylon Locking Nuts (silver zinc)
2) 1/2” - 13 x 1 1/2” Hex Bolts (black zinc)
4) 1/2” Flat Washers (black zinc)
2) 1/2” Nylon Locking Nuts (black zinc)
*May include extra hardware*
Pro-Series
Bumper Replacement
Installation Instructions
58647W
Ford Super Duty 2017
Note: Completely read instructions before beginning installation!
1.
Remove the contents from the box and check for missing or damaged parts. If parts are missing or damaged, contact the original place of
purchase.
2.
Unplug any electrical connectors between the bumper and the vehicle. Then begin the bumper disassembly by removing the 4 bumper
support bracket bolts which are behind the bumper and near the outside corners. Next, remove the 8 bumper bolts shown in Diagram 1, and
carefully remove the bumper.
3.
Remove the tow hooks, factory bolts, and anti-dive brackets if equipped, and set them aside as they will not be reused. Using
Diagram 4
,
place driver main bracket #59647-5 onto the top of the frame using (8) 1/2” x 1 1/2” bolts, (16) 1/2” flat washers and (8) 1/2” nylon lock nuts to
attach the driver main bracket #59647-5 to the frame. Repeat the preceding procedure to install the passenger main bracket #59647-6.
4.
If a winch and fairlead is to be used, install it at this time as per the manufactures installation instructions.
5.
Place the bumper replacement up the brackets installed in step #3. Place (1) 1/2” flat washer onto the remaing 1/2” x 1 1/2” bolts. Insert the (8)
bolts with washers through the bumper replacement and brackets. Place (1) 1/2” flat washer and (1) 1/2” nylon lock nut onto each of the 1 1/2”
bolts.
6.
The bumper and brackets are slotted for side to side as well as up and down adjustment of the bumper. Center the bumper onto vehicle and
tighten all bolts and nuts. With all the adjustment the bumper has in it, it can sometimes make it tricky to get the bumper aligned and
centered. It may require bolts to be loosened and tightened to get it aligned.
