16 |
Stand
An optional stand for the scooter is available. It is attached from the inside to the rear fork. The stand provides a
firm position for the scooter. The scooter must be on secure and flat terrain, otherwise the vehicle could tip over
through it being tail-heavy. Baskets and bags on the handlebars impair the stability.
The stand can be installed retrospectively at the rear lefty fork: Remove the rear brake caliper by unscrewing both
screws. Lift the caliper off the brake disc. Unscrew the screw that holds the rear wheel on the axle and pull the rear
wheel off the axle. Now you have access to the two screw points of the fork. Screw on the stand so that the cranked
part of the mounting plate faces outwards, tighten the screws with 10NM. Slide the rear wheel onto the rear axle
and tighten the axial fixing screw with the washer. Check that the wheel runs smoothly. Mount the brake caliper and
align it.
On scooters with V-fork (ER models) the brake caliper can remain mounted. The drive motor must be removed.
To do this, disconnect the plug connection at the rear of the fender plate. Loosen the motor screws on the left and
right. Then pull the discs with the anti-rotation device outwards until the motor shaft can easily fall downwards
from the dropouts. Now the stand can be mounted. The motor is then reassembled in reverse order.
Always make sure to fold
the stand in before start
riding.
