GB
14
Only replace the blade with a genuine Einhell
replacement blade, as this will ensure top
performance and safety under all conditions.
Carry out the following steps to change the blade:
Undo the fastening screw (Fig. 7).
Remove the blade and replace with a new one.
When fitting the blade, make sure it is installed in
the right direction. The blade’s air vanes must jut
into the motor compartment.
Then retighten the fastening screw. The
tightening torque should be approx. 25 Nm.
9.3 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
9.4 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9.5 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
10. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
Anleitung_ERM_900_30_SPK7:_ 03.12.2008 14:55 Uhr Seite 14
Summary of Contents for 34 002 42
Page 4: ...3d 3a 3c 4a 3b 4b 8 L H 9 10 12 12 4 Anleitung_ERM_900_30_SPK7 _ 03 12 2008 14 54 Uhr Seite 4 ...
Page 6: ...6a 7 8 1 3 4 7 6 5 6b A 3 A 2 1 2 6 Anleitung_ERM_900_30_SPK7 _ 03 12 2008 14 55 Uhr Seite 6 ...
Page 49: ...49 Anleitung_ERM_900_30_SPK7 _ 03 12 2008 14 57 Uhr Seite 49 ...
Page 50: ...50 Anleitung_ERM_900_30_SPK7 _ 03 12 2008 14 57 Uhr Seite 50 ...