Original Instruction Manual
En
Kickback is the result of power tool misuse and/or incorrect operating procedures or
conditions and can be avoided by taking proper precautions as given below.
a)
Maintain a firm grip on the power tool and position your body and arm to
allow you to resist kickback forces. Always use auxiliary handle, if provided,
for maximum control over kickback or torque reaction during start-up.
The
operator can control torque reactions or kickback forces, if proper precautions are
taken.
b)
Never place your hand near the rotating accessory.
Accessory may kickback
over your hand.
c)
Do not position your body in the area where power tool will move if kickback
occurs.
Kickback will propel the tool in direction opposite to the wheel’s movement
at the point of snagging.
d)
Use special care when working corners, sharp edges etc. Avoid bouncing
and snagging the accessory.
Corners, sharp edges or bouncing have a
tendency to snag the rotating accessory and cause loss of control or kickback.
e)
Do not attach a saw chain woodcarving blade or toothed saw blade.
Such
blades create frequent kickback and loss of control.
WARNING
Some dust created by power sanding, sawing, grinding, drilling, and other construction
activities contains chemicals known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
- lead from lead-based paints,
- crystalline silica from bricks and cement and other masonry products, and
- arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
INTENDED USE
The machine is intended for grinding metal and stone materials without using water.
TECHNICAL SPECIFICATIONS
Model:
S1M-KM18-125C-A
Voltage:
230-240 V ~ 50 Hz
Power consumption:
750 W
Rated speed:
12,
000 minˉ¹
Drive spindle diameter:
M14
Max. grinding disc size:
125mm x 6mm
Sound pressure level L
pA
87,6 dB(A) k = 3 dB(A)
Sound power level L
WA
98,6 dB(A) k = 3 dB(A)
7
01/2017
