Original Instruction GB
15
1. Cut the grass by swinging the machine from right to left and proceed slowly keeping the
trimmer inclined forwards at an angle of about 30°
2. High grass should be cut in layer always beginning from the top. Do not cut damp or wet
grass; do not overload your machine.
3. Avoid wearing the line out quickly by knocking against hard objects (stones, walls, fences etc).
4. Watch out for kickbacks in the event of impact with hard objects.
WARNING: Never pass the machine over the extension cable while the machine is running,
make sure it is always in a safe position behind your back,
Changing spool
(Fig 22)
Fig. 22
1. Unplug the tool
2. Keep the tabs
①
depressed and remove the spool cover
②
from the housing
④
.
(F)
3. Remove the empty spool
③
from the spool cover.
(F)
4. Remove any dirt and grass from the spool cover and housing
5. Taking the new spool and push it into the boss in the spool cover. Rotate the spool slightly until
it is seated.
6. Unclip the end of one of the cutting lines and guide the line into one of the eyelets
⑤
. The line
should produce approx. 10cm from the spool corner. (
G
)
7. Unclip the end of the other cutting line and guide the line into the other eyelet. The line should
produce approx. 10cm from the spool corner.
8. Align the tabs
①
on the spool cover with the cut outs
⑥
in the housing.
(G)
9. Push the cover onto the housing until it snaps securely into place.
CAUTION! Under no circumstances wind extra line on the empty spool but instead replace
it with a new one, the same as the original. The use of line with different characteristics to
those of the original can permanently damage the grass trimmer as well as annulling the
terms of the guarantee.
Warning!
If the cutting lines protrude beyond the trimming blade, cut them off so that they just
reach the blade.
