Gobo Changing & Focusing Instructions for
ECO Spot 25E/40E/60E - Series Gobo Projectors
This instruction sheet is meant to assist you in installing and changing out
Gobo’s from the unit’s Gobo holder, as well as give a basic overview of
how to focus your gobo image that is being projected.
These instructions are based on the example of an ECO Spot E-series
projector. E-series projectors are designed for exterior applications but are
also suitable for interior use.
These instructions also work for most other ECO Spot models.
Please read the user manual before installing or operating this fixture, fol-
low the safety precautions listed in the manual and observe all warnings.
www.GoboSource.com
Installing and Placing Your Gobo
(see Specifications for Gobo Dimensions)
1. Unscrew the thumbscrews to remove the front cover with the projection lens. Keep rubber and metal seals.
2. Push the two pins of the gobo retaining ring together and pull out the retaining ring.
Carefully remove the old gobo and replace it with the new gobo.
3. Tilt the projector forward while placing the palm of your hand inside,
the old gobo will fall into your hand.
4.
If you have a glass gobo, place the more reflective side towards the light bulb.
5. Replace the retaining ring and make sure it evenly pushes the gobo all the way back.
6. Replace the front cover (with rubber and metal seals if unit is exterior) and adjust the focus by threading
the projection lens in or out.
Copyright © 2017 Globus New Media LLC
Page 1
1. Unscrew Faceplate
2. Remove Gobo Ring
3. Carefully Remove
4. Insert Gobo
5. Replace Gobo Ring
6. Screw on Faceplate
