91
6.5 SWITCHING ON THE DEVICE
Once you have connected the device to a power source, you can now switch it on.
Since power consumption is an important factor, especially in a vehicle, the device
has a physical on/off switch on the back. Please make sure that the switch is set to
“On” before proceeding with the next steps.
Information – Stand-by
When switching off the TV using the remote control, you can select the appropriate
mode by pressing the button (switch on & off) briefly or for longer:
Pressing briefly = stand-by mode
In this mode, the TV set does not shut down completely, and switching the device
back on is quicker (less than 5 seconds). In this mode, the TV set deactivates all
functions (such as interfaces, display etc.) but continues to run in stand-by mode.
However, the energy consumption is higher in this mode than in “deep stand-by”.
Pressing for longer = deep stand-by
In this mode, the TV set shuts down completely. In “deep stand-by”, the energy con-
sumption is < 0.5 W. When the TV is switched back on again, it reboots completely
(this takes up to 30 seconds).
6.6 STARTING THE DEVICE
When the TV set is switched on for the first time, an installation wizard opens to
guide you through the device’s most important basic settings. Follow the corre-
sponding instructions.
1. Confirming the privacy policy
You must accept the privacy policy in order to use
the device and its apps in conjunction with the internet. If you reject it, the device
cannot be connected to the internet.
2. System language setting:
Select the desired system language. As our devices are
designed to be used throughout Europe, there are over 20 languages to choose from.
3. Network setting:
Configure the desired connection type of the device with the
internet here. You can choose between a LAN connection (lower left tile) and a
connection via a WLAN network (upper left tile). Select the corresponding tile using
the navigation buttons on the remote control and complete the corresponding con-
figuration.
