4
The external SD memory card is made of precise electronic components. Data may be
lost or damaged under the following circumstances:
a. Improper use of the memory card, the memory card is bent or dropped.
b. Place it under high temperature or moist environment or expose to sunshine
directly.
c. Electrostatic or electromagnetic field exists around the memory card.
d. This memory card is taken out or power supply is interrupted when this video
camera or computer is connected to the memory card (i.e. during reading, writing
and formatting).
e. Touch the metal contact surface of the memory card with fingers or metal materials.
Waterproof Case
Before sealing the waterproof case, keep the camera housing’s rubber seal clean, a single hair
or grain of sand can cause a leak. You can test by closing the case without inserting the
camera. Submerse the case completely in water for about a minute. Remove the case from
the water, dry off its exterior with a towel, then open the case. If the entire interior is dry, the
case is safe for use under water.
Remember to put the Mode Switch in your desired recording position before inserting
the camera in the waterproof case. There is no external button for the Mode Switch.
After every use in salt water you will need to rinse the outside of the housing with non-
salt water and dry. Not doing this can eventually cause corrosion of the hinge pin and
salt buildup in the seal, which can cause failure.
