Goddess CL 801, Instruction Manual

ENg

ENG - 29

hOw TO CLEAN ThE hEPA fILTER

It is very important to keep the filters clean to receive maximum performance from the vacuum.

Clean the filter regularly and replace the filters when necessary.

HEPA Dust Cup Filter will stop most of the tiniest dust particles and airborne allergens from 

reentering the air you breathe. In fact it stops 99.97% of all particles as small as 0.3 microns-

many times smaller thana human hair! Because of this incredible filtration performance, the 

HEPA Filter will quickly accumulate may fine dust particles inside the white filter folds that are 

difficult to see but which will eventually block or reduce your suction power, if not cleaned prope

-

rly. We recommend washing it once a month or when suction appears to be reduced. To wash 

your HEPA Filter, hold filter cartridge by frame flange and rinse under a tap until all observable 

dirt has been removed. Some discoloration of the HEPA filter material may occur, this is normal 

and will not affect the filter‘s performance. When finished, shake off excess water.

Do NOT wash in dishwasher. It is important that when you wash the HEPA filter, you allow it to 

dry COMPLETELY before using again. We recommend 24 hours to air dry. DO NOT DRY IN 

DRYER.

The HEPA filter operating lifetime corresponds to about 10 to 15 washing cycles. After that, the 

filter looses its performance and it should be replaced.

Caution!

Only ever clean the filter with clean water and do not use soap or detergent. These would 

destroy the filter.

TROUbLE-ShOOTINg

Faults can occur on all electrical equipment. This must not necessarily be due to a defect in the 

device itself. So check first with table if the fault can be dealt with.

PRObLEM

POSSIbLE CAUSES

SOLUTIONS / TIPS

Weak suction

The secondary valve is open. Close the secondary valve
An object is blocking the sucti

-

on pipe

Check the suction tube, the 

handle area, suction pipe and 

the nozzle in use for blockages.

Filters are not fitted properly   

or are blocked

Fit a new filter

Device does not work.

Device is not properly plugged 

into the mains

Check that the mains plug 

has been inserted properly. 

Also check whether the power 

socket is in order (e.g. use 

an electric torch). Check the 

fusels! Automatic fuses in the 

fuse box

Thermostat automatic turned 

off the unit

Follow instructions on page 26, 

section Motor thermostat

Don´t close front cover

Isn´t the filter bag placed in 

the body. Isn´t the sitting cor

-

rected

Please replace correctly the 

filter bag

The cord can not be retrated Isn´t the core tangled?

After unfastening tangled cord. 

Pull out the by 1 or 2 meter and 

push button to wind it again.