ENG
ENG - 15
DETERGENT DRAWER
Detergents may form a sediment in your detergent drawer or in housing of the detergent drawer
in time. To clean the sediment, pull out the detergent drawer from time to time.
To pull out the detergentdrawer:
• Pull the detergent drawer to the end. (DIAGRAM-1)
• Lift the front of the drawer, continue to pull until the drawer is pull out. (DIAGRAM-2)
• Wash will an old toothbrush and excessiveamount of water.
• Take off the leftover detergent avoid to drop into your machine.
• After drying the detergentdrawer put into the housing in the same manner you pull out.
DIAGRAM 1
DIAGRAM 2
SIPHON PLUG
Pull out the detrgent drawer. Remove the siphon plug and clean the residues of the softener
thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly.
THE CABINET
Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning
substance that will not irritate the cabinet. After rinsing with clean water, wipe it with a soft and
dry cloth.
WARNING
If the machine is installed in a location where the ambient temperature can fall below
0˚C, do the following when it will not be in use:
• Plug in the machine.
• Close the water tap and pull out the water inlet hose or hoses from the tap.
• Place the ends of the water drain and water inlet hoses in a cup on the ground.
• Adjust the program knob to “Draining” program.
• The program ready light will be on.
• Run the program by pressing the start/pause button.
• Unplug your machine when the program is over (program end light is on).
When you complete these proces, the remaining water inside the machine will be drained and
thus formation of ice in the machine will be prevented. When you operate your machine again,
be sure that the ambient temperature is above 0 ˚C.
Summary of Contents for WFD 1025 M8
Page 20: ...ENG ENG 20 SECTION 10 INTERNATIONAL WASHING SIGNS ...
Page 22: ...Notes ...
Page 23: ...Notes ...
Page 24: ......