29
5.2.4 Formatting the applicator interface (!)
It is necessary to format the applicator interface by sending the command ^XSET,APPLICATOR,0,1
to the printer. For more details, please see the printer manual.
5.2.5 Smart backfeed
The smart backfeed function is currently (April 2016) not supported in applicator mode.
5.2.6 Create a label and load media
Now create a label and store it on the printer. Always select the applicator mode in either the
software or the driver you are using. Load the printer with suitable media and TTR if applicable. The
printer is ready to go now. For more information regarding creating labels and handling the ZX
printer, please see the printer manual.
Putting the applicator into service
5.3.1
Air supply
Connect the AG3000 to a pressed air supply. The required pressure is at least 4,5bar. The system’s
air intake valve protects the applicator against too high pressure. You insert the end of an 8mm air
hose into the quick coupler on the backside of the control box:
Picture 1: AG3000 air intake coupler
5.3.2 Checking the mechanical settings (!)
Basically no adjustment of the mechanical parts is needed. During its production the applicator
has been tuned to be a perfect fit with the printer, out-of-the-box. But due to transportation and
re-assemblage certain elements might require fine-tuning after all. Therefore, it is a must to check
the correct position and - functioning of the crucial before putting the AG3000 into operation.
Summary of Contents for AG3000
