35
6.
Mechanical and pneumatic adjustments
6.1
Manual menu
You must first open the “MANUAL” menu to adjust mechanical settings on the applicator:
• Bring the device in stop mode
• Press the “DOWN” arrow whilst the device is in “STOP” mode to open the “SERVIS 1
menu”, confirm the preselected settings with “ENTER” and select the “DOWN” key again.
6.2
Applicator head alignment
It is required to align the applicator head in case:
• In start position its bottom is higher than the upper end of the peeler edge
• In start position its bottom is lower than the upper end of the peeler edge
• The distance between the head and the peeler edge is less than 0,5mm
• The distance between the head and the peeler is more than 1,0mm
• The head and the peeler edge are
not parallel Picture 1: correct
Alignment.
Picutres 2 & 3: re-align the applicator
head
Summary of Contents for AG3000
