21
3-2 Label size calibration and Self Test Page
The printer can automatically detect and store label height.
That means the host computer does not need to transmit the label height to the printer.
And the self-test function lets you check whether the printer is functioning normally.
Here is how you run the label size calibration and self test.
Step.01 Check that the label stock is loaded correctly.
Step.02 Switch off the printer.
Step.03 Switch the printer on again, keeping the FEED button pressed. When the READY LED starts to flash
red and the STATUS LED lights up orange, release the FEED button. The printer will now measure
the label stock and store the label height
Step.04 Once the printer has successfully measured the label stock, it will print a self-test label.
The contents of a self-test printout are listed below.
(The data below is for reference only, actual result may vary according to each situation.)
Model & Version
USB ID setting
Serial port setting
Number of forms
Number of graphics
Number of fonts
Number of Asian fonts
Number of Databases
Number of Scalable fonts
Free memory
size
Speed, Density, Ref. Point, Print direction
Label width, Form length, Stop position
Cutter, Label Dispenser, Mode
Sensor Setting
Code Page
