Godex EZ-2P, User Manual

9

We suggest that the minimum label height be more than 20 mm. 

B. Load large label roll 

1.  Open the Front cover and back cover. 
2.  To load a label roll onto the roll core (part 17). 
3.  Remove the label roll stands (part 23). Vertically 

place the two stands along the left side and right 
side of the back cover (see Fig. 2.3.3). 

4.  Place the large-size label roll on the stands (see Fig. 

2.3.3). 

5.  Press the printer locks (part 14) to loosen the printer 

head assembly. 

6.  Turn over the assembly. Pass the front edge of the 

label roll through beneath the gap sensor (see figure 
2.3.2). 

7.  Put back the printer head assembly and fasten it by 

pressing down from the top of it. 

8.  Close the front cover. 
9.  Press the feed button (part 7) to feed out labels.

Fig. 2.3.3

Note:

DT (Direct Thermal) mode: using direct thermal paper   

        TT (Thermal Transfer) mode: using thermal transfer paper 

C.   Fan-fold type media setting 

1.  Open the back cover. 
2.  Take out the two Big Label Roll Stands (part 23) 
3.  Insert the paper into the Fan-fold Media Entry (part 

25) of the back cover. 

4.  Push and release the printer locks (part 14) to open 

the printer head. 

5.  Turn over the opened printer head assembly. Pass 

front edge of the labels under the gap sensor. 

6.  Adjust the label guide (part 26) to fit in the label's 

edge (see figure 2.3.2). 

7.  Put back the printer head assembly and fasten it. 
8.  Close the front cover and back cover (see figure 

2.3.4). 

9.  Push feed button (part 7) to feed out label. 

Fig. 2.3.4 

D.   The media setting for the Laying down printing 

1.  Open the front cover and back cover. 
2.  Hold the open end (the apron) of the Core Guide, lift it up 

about 5 mm then turn it round 180 degree and snap in the 
little hole. 

3.  Follow the above steps to adjust another Core Guide. 
4.  Press the printer locks (part 14) to open the printer head. 
5.  Turn over the opened printer head assembly. Pass front 

edge of the labels under the gap sensor. 

6.  Adjust the label guide (part 26) to fit in the label's edge (see 

figure 2.3.2). 

7.  Put back the printer head and fasten it. 
8.  Close the front cover and back cover. 

LIFT UP AND TURN
ROUND 180 DEG.

Fig. 2.3.5