14
2-7. To Install Memory Card
There are three types of external memory card (Flash Card, SRAM Card and Font Card) for
EZ-4TT. All the external memory cards have the same setting method. There is no difference
between the left and right slots. You might insert any of the above external memory cards into
either slot. Please follow the steps.
1. Power off the printer.
2. Open the front cover.
3. Put the tip of a screwdriver into the little groove which protects the Lids that cover the slots.
Lift the Lid off carefully with the screwdriver.
4. Please refer to the following diagram to insert the external memory card(s) into the slot(s).
(see figure 2.7.1)
Regarding the 2 memory card slots in EZ-4TT, you only can use it under one of the following
situations.
1. One SRAM card only.
2. One Flash memory card only.
3. One SRAM card & one Flash memory card at the same time.
Fig.2.7.1
Warning:
Power off the printer before
installing the memory card.
It is prohibited to use either two
SRAM cards or two Flash memory
cards at the same time.
2-8. To Install the Cutter
We suggest that the minimum label height be more than 35 mm. If you need any help in
installation and maintenance, please consult your supplier or dealer.